Bond-It | Patio Sealer
Bond-It Drive Alive Paving and Patio Sealer is a solvent free, acrylic liquid used to seal and protect patios, paths, natural stone, concrete and block paving from sunlight, water, oil, petrol and fungal growth.
Bond-It Drive Alive Paving and Patio Sealer is supplied in 5 Litre Containers, ready to use.
Drive Alive Patio Seal protects block paving driveways and pathways and patios against water penetration as well as spillages of contaminants, such as oil and grease.
Drive Alive Patio Seal will also deter dirt and grime build-up and will enhance both the present colour of the paths and greatly extend the lifespan of the driveway.
Solvent Free formulation - Low odour.
Facilitates easier cleaning.
Improves water resistance and UV resistance.
Retards mould growth.
Remove organic growth/ lichens, etc. that may be present.
For best results use Platinum Moss & Algae Cleaner prior to application.
Wash all debris away and ensure the surface is dry and free from oil, grease, dust and loose material that may hinder adhesion.
Drive Alive Patio Seal is ready to use, and does not require diluting. We advise that you test this product on a small inconspicuous area prior to use to check compatibility.
Shake well before use and ensure that the surface is completely dry.
Apply a single coat using either a brush, roller or squeegee, ensuring no pooling or ponding occurs. Allow 3-4 hours drying time before trafficking the area.
Application temperature should be between 5°C and 30°C. Colder humid conditions will slow drying times.
Do not apply Drive Alive Patio Seal to wet surfaces or in conditions of high humidity. Do not use when rain is forecast (protect from rain until dry). Do not apply to non-porous surfaces.
Keep children and pets away from treated areas until fully cured.
Do not allow any run off to contaminate drains, waterways or plants.
It is the users responsibility to determine suitability for use.
Areas treated with this product can be cleaned with warm water and detergent or Platinum Moss & Algae Cleaner. Do not use acid based cleaners, as these will remove / discolour the product. Also avoid using power washers.
It is advisable to use this product during warmer/drier months (April - October).
A single coat application will cover approximately 10m²-15m² per litre depending on surface porosity.
We've added to your cart