Wykamol Group | Woodworm & Dry Rot Treatment
Wykamol Microtech Dual Purpose is a highly effective Super Concentrated Woodworm & Timber Rot Treatment used for the eradication and prevention of Woodworm (and other wood boring insects) and Wood Rotting Fungi (Dry Rot and Wet Rot).
Wykamol Microtech Dual Purpose should only be used on Timbers. For an effective Dry Rot Treatment on Masonry substrates, see Microtech Masonry Biocide.
Wykamol Microtech Dual Purpose dilutes with water to make up to 25 Litres of Ready-to-use product.
Supplied in 400ml Containers, Concentrated Solution.
Wykamol Microtech Dual Purpose carries the HSE Approval No 10608.
Read our Guides on 'How to Treat Woodworm & Wood Boring Insects' and 'How to Identify & Treat Dry Rot and Wet Rot on Timbers'
Wykamol Microtech Dual Purpose Concentrate is a Dual Woodworm & Dry Rot Timber Treatment supplied as a 400g concentrate which requires dilution with water to form a ready to use product.
Wykamol Microtech Dual Purpose Concentrate offers a solution to a range of wood destroying issues.
Containing both insecticide and fungicides, Microtech Dual Purpose Concentrate both protects against and eradicates wood boring insects, wood rotting fungi (both wet rot and dry rot) and blue stain.
Due to the microscopic size of the active ingredient, Microtech Dual Purpose is highly penetrating and therefore ultra-effective and long-lasting.
Wykamol Microtech Dual Purpose has virtually no odour and can be applied either by brush or low pressure spray to give long lasting protection.
Dilutes to make up to 25 litres of Ready-to-use Product
Eradicates Wood Boring Insects and Wood Rotting Fungi
Prevents Fungal Decay and Blue Stain
Suitable for Interior and Exterior Use
Can Be Applied Using Brush or Low Pressure Spray
Solvent Free and Helps Prevent Waste Pollution by Reducing Single Use Plastic Containers
Permethrin 13.02% w/w: The insecticide is effective against all life stages of wood boring insects whilst the surfactant system used in the formulation promotes rapid absorption and deep penetration into timber.
Propiconazole 18.584% w/w: A Triazole Fungicide which has excellent efficacy against a range of wood destroying fungi.
IPBC (3-Iodo-2-Propynyl Butyl Carbamate) 6.125% w/w: A Carbamate Fungicide which is added to improve the efficacy envelope even further providing excellent efficacy against a range of wood staining fungi.
Take the usual labour hygiene into account.
PPE should be worn during application. See our Safety & PPE Products.
Consult label and material safety data sheet for more information.
The active ingredients in this product have been accepted by the nature Conservancy bodies as suitable for the treatment of roof voids where bats roost.
However, it is a legal requirement to notify the appropriate Nature Conservancy body prior to any treatment of roof spaces where bats have been identified. Treatment must not be carried out whilst bats are at roost.
Ensure that all timbers to be treated are clean and free from wood dust and other contaminants.
Any paint, varnish or other surface coatings should be removed prior to application.
If decay is present, remove all decayed wood and replace with suitably treated timber.
Always consult the Safety Data Sheet before commencing application.
Microtech Insecticide can be applied using a brush, low pressure spray or dipping.
Agitate the solutions well before use.
Perform a test on a small, inconspicuous area before commencing complete application to ensure product finish is as expected.
For application with low pressure spray or brush.
Where possible dip the end grains of timber for a maximum of 3 minutes, otherwise use a good quality brush to work the product into the grains.
Apply at a rate of 1 Litre per 3 - 4m², once diluted.
Wykamol Dual Purpose has a HSE statutory 1-hour re-entry time.
Product does not have a finish and leaves the same effect as applying water or solvent. It is always advisable to try on a small inconspicuous area before application to ensure product finish is as expected.
Over coating can occur 24 hours after application, depending on the substrate and ambient temperatures.
Product is stable in original packaging for 2 years when stored under ambient conditions. After 2 years product should be re-tested every 6 months to ensure active ingredient levels are within specification.
We've added to your cart