Platinum Building Chemicals Ltd | Anti-Condensation Paint
ThermSolve Anti condensation paint is an independently tested, complex blended thermal performance coating system which will drastically reduce condensation formation by utilising Glass Microsphere Technology.
As condensation is reduced, unsightly and potentially harmful black mould will not grow.
The Glass Microspheres effectively become 'charged' like a battery cell which enables them to retain heat for much longer compared to other decorative or specialist paints.
ThermSolve Anti Condensation Paint maintains surface temperatures on walls and ceilings which reduces the formation of surface condensation.
Unlike other anti-mould or anti-condensation paints which contain biocides or simply only absorb moisture, ThermSolve Anti condensation paint can be overpainted and is an ideal solution for cold, exposed walls or areas where insulation may be missing or inadequate.
Available in 2.5 Litre or 5 Litre Buckets.
Reduced condensation and mould growth helping prevent the build-up of harmful spores which can cause respiratory, skin and immune problems.
Prevents formation of condensation.
Minimum preparation and disruption.
Perfect for use internally on those external cold exterior walls and areas of missing insulation.
Can be painted or wallpapered over unlike biocidal or absorbing anti-mould paints.
Surfaces should be clean, dry and free from grease and dirt. Remove all loose and defective paint. Lightly abrade glossy areas with abrasive paper.
Avoid inhalation of dust. Wear a suitable face mask when dry sanding.
Treat any visible mould with ThermSolve Preparation Treatment Spray.
Ensure the area is well ventilated.
Stir gently and thoroughly before use. DO NOT use a powered mixing paddle.
Application temperature between 5°C - 25°C.
Optimum dry film thickness is 200 microns.
The product should be touch dry after 2 hours depending on humidity and temperature.
Re-coat after 4 hours. Allow for extra drying time in cold and wet weather conditions.
For best results, use a medium pile roller. Can also be brush applied.
Over paint with a standard emulsion to achieve a smoother finish. You can also apply wallpaper over this coating.
Internal use only on walls and ceilings. Can be applied to block, brick, render and plaster
New plasterwork should be allowed to dry completely before applying ThermSolve.
Approximately 4-5m² per litre. 2 coats required.
Remove as much product as possible from equipment before cleaning with warm water.
We've added to your cart