Soudal | Mirror Adhesive
Soudal Soudaseal® Mirror is a Hybrid Polymer based Mirror Adhesive and Sealant which has a high bond strength and fast cure on to nearly all surfaces, even when damp.
Soudal Soudaseal® Mirror has high performance mechanical properties and excellent extrudability, even at low temperatures.
Soudal Soudaseal® Mirror is free of isocyanates, silicone, solvents and acids meaning health and safety considerations are minimal.
Soudal Soudaseal® Mirror is resistant to many chemicals and withstands mould growth. There is also no staining of porous materials such as natural stone, blue stone, marble and granite when applying Soudaseal® Mirror.
Soudal Soudaseal® Mirror is compatible with all acetone resistant mirrors.
Hybrid Polymer Sealant & Adhesive
Primerless adhesion even on damp surfaces due to unique adhesion promoters.
Stays elastic after curing and very sustainable.
No odour and does not contain solvents.
Does not contain isocyanates and no silicones.
No risk for staining on porous substrates (migration of plasticizer).
Sealing and bonding of mirrors on to most types of surfaces.
Sealing of joints in mirror walls.
Bonding of mirrors even on damp surfaces.
Water resistant bonding.
Surfaces should be clean, dry, free of dust and grease.
Porous surfaces in water loaded applications should be primed with Soudal Primer 150. All smooth surfaces can be treated with a Surface Activator.
Soudaseal® Mirror has excellent adhesion on most substrates. Soudaseal® Mirror can also be used on natural stone.
There is no adhesion on PE, PP, PTFE (Teflon®) and bituminous substrates. We recommend a preliminary compatibility test.
Application Method: With a manual or pneumatic caulking gun. Apply Soudaseal® Mirror with attached V-cut nozzle in vertical adhesive beads on the back of the mirror. Depending on the weight of the mirror an adhesive bead shall be applied every 10 to 20cm.
Cleaning: Clean with a Sealant Remover.
Finishing: With a soapy solution or Soudal Finishing Solution before skinning.
Repair: With the same material
Due to the wide variety of types of mirrors, we strongly recommend preliminary compatibility tests.
Due to the low initial tack, the mirrors need to be supported during the curing process until the adhesive has fully cured. The time required depends on the weight / size of the mirror, temperature, relative humidity and the amount of product used.
In order to avoid possible problems due to condensation, the mirror manufacturers as well as Soudal recommend sufficient ventilation at the back of the mirror. As a guideline, an opening of 3-4mm should be left between the surface and the mirror. This can be assured by the use of double sided mirror tape.
We recommend this minimal ventilation opening of 3-4mm to ensure correct curing of the adhesive / sealant. Full surface bonding is at own risk of the applicator.
For larger mirrors always use the adhesive in combination with a very good and qualitative double-sided adhesive mirror tape.
Mirrors that are fitted with a safety film at the back to avoid shattering must be pre-treated with an adhesion promoter. The use of Soudal Surface Activator will ensure the best bonding performance on this type of safety film. Without the use of Soudal Surface Activator the adhesive bond might be insufficient with the risk of an unsafe situation.
We've added to your cart