Wykamol Group | Mould Control
The Mould Control System (MCS) is a two stage treatment for walls, ceilings etc. affected by condensation mould. When both stages are completed, surfaces will exhibit excellent resistance to mould growth even under severe condensation conditions.
Typically, full control can be achieved for up to 5 years but this can be extended considerably where moisture control measures are implemented.
Supplied as a concentrate, MCS1 Mould Clear 5X is designed to provide an initial wash/ sterilisation treatment to remove and kill mould spores and surface growths on painted or papered surfaces.
We recommend the wash is applied before removing mould-damaged paint or paper (to minimize spread of viable spores). When applied liberally to papered surfaces it can be an effective stripping agent.
After the first wash, and once damaged paper or plaster has been removed, it is necessary to apply a second wash with Mould Clear solution to leave the surface clean and remove any residues of dead spores etc. It is recommended that mould affected woodchip and Anaglypta papers are always removed and arenot recommended for re-instatement.
Based on established active ingredients, the Mould Clear solution both cleans and sterilises the surface as the first stage towards redecoration.
Alternatively, it can be used singly, as required, to control spore development where other measures are to be completed at a later time.
MSC1 Mould Clear Solution carries the HSE Approval No 7667.
Supplied in 5 Litre Containers, concentrated solution dilutes 1:4 with clean water to make 25 litres.
Can be used on walls, ceilings, window reveals, frames, doors etc.
Removes and kills mould for up to 5 years when used in conjunction with MCS3 Paint Additive.
Cleans and sterilises surfaces.
Dilute one part of concentrate with 4 parts of warm water.
Once diluted, spray MCS1 Mould Clear Solution onto the affected surface from a distance of 3-5cm.
Treat visible mould PLUS 1 metre beyond. Repeat the treatment on badly affected areas after 10-15 minutes.
Areas to be treated
Painted & Timber Areas - Spray the area thoroughly with the MCS1 Mould Clear Solution.
Papered Areas - Spray the paper. The MCS1 Mould Clear Solution acts as a biocide and stripping agent. Bag the mould contaminated paper and remove from the property. Treat the exposed plaster with a thorough spraying of MCS1 Mould Clear Solution.
General Preparation - Once the surface is dry, scrape off any loose flaking paint and rub down. Previously painted surfaces must be etched using sandpaper.
Once diluted, the solution should cover approximately 12.5m² per litre.
MCS1 Mould Clear Concentrate 5X contains Benzalkonium Chloride & Ortho Phenol Solution 11.9% w/w; Quaternary Ammonium Compounds; Benzyl-C8-18-alkyldimethyl Chlorides.
We've added to your cart