Product Description
A cement based, rapid curing non shrink hydraulic setting powder. Used at points of stress i.e. floor/wall or wall/wall junction and applied normally by trowel.
One of the potentially weakest points of any structural waterproofing application process is the floor/wall junction and particular attention to this detail is required.
Wykamol Fillet Seal is specifically formulated to tackle this problem area as part of their tanking system using either Aquastop or Hydradry Tanking Slurries.
Special Features
Acts with water and free lime present in the substrate to react with the active chemicals in the product quickly forming and developing a continuous barrier of insoluble crystals which penetrate deep into the pores of concrete, blocking capillaries and leaks from the further passage of water, whilst permitting the transmission of air and water vapour, enabling the structure to breathe. Once fillet has set, the active chemicals remain dormant until any subsequent contact with water reactivates the sealing process.
Application
At floor wall junction chase out the floor to a minimum of 25mm from the wall and 25mm into the floor, cutting into the wall where possible.
Flush out chase formed to remove grit dust etc., and whilst still damp fill chase with Wykamol Fillet Seal.
Gauging Water: 3-3.5 L water per bag.
Mixing: first add water to mixing vessel, then the contents of the bag.
Setting time: Is similar to a sand/cement mortar i.e. overnight
Press fully into chase and whilst still green form a “bottle” cove.
Apply Wykamol Fillet Seal to all vertical internal angles and again form a rounded “bottle” cove.
Wykamol Fillet Seal should also be applied to the wall/ceiling joints of vaults if relevant.
Coverage
Applied at a rate of 15-20 linear metres per 25kg bag subject to site conditions and requirements.
Product Data Sheets
Technical Data Sheet Safety Data Sheet
