Product Description
A crease resistant lead coloured flashing tape for general repairs and sealing. It has a heavy duty aluminium/polyester laminate facing with a high grade bitumen backing. This gives the product tear resistance, thus aiding speed and ease of application.
Application
1. Cut a section of Flashing Tape to the required length, remove the release paper and press down the adhesive bitumen to the previously prepared surface.
2. Ensure full contact by smoothing down with a cloth, taking care to eliminate air bubbles.
3. Roll down the edges with a wall paper roller or trowel to make a good edge seal. take care to avoid damaging the Flashing Tape surface.
4. Joined sections of Flashing Tape. should always be overlapped by a minimum of 25mm (one inch) and well rolled down.
Note: in cold weather adhesion will be improved by storing the roll in a warm room for 12 hours or more before use, or by gently warming the backing strip during application.
DO NOT UNDER ANY CIRCUMSTANCES APPLY IN CONDITIONS BELOW 5°C.
Coverage
As per roll length.
Product Data Sheets
Technical Data Sheet Safety Data Sheet
