Product Description
Platinum Polyester Resin 380 is a rapid curing "one shot" two-part chemical anchoring cartridge system based on an unsaturated polyester resin in Styrene.
Applied in one single action to produce a cost effective, tough, chemical resistant fixing.
Platinum Polyester Resin 380 is ideal for close-to-edge applications (unlike expansion anchors) as no stress is placed on the surrounding substrate. Versatile in use, Platinum Polyester Resin 380 is suitable for fixing wall ties, starter bars, studs, bolts or large screws in a wide range of substrates including brickwork, concrete, masonry, stone and PFA blocks.
Hollow base materials can be securely fastened into by using Platinum Polyester Resin 380 in conjunction with a sleeve or sieve.
Product Uses
- As a bonding agent.
- Where a waterproof bond is required.
- Where a chemically resistant bond is required.
- Where a vibration-proof bond is required.
- When bonding near to an edge.
- Where a stress free bond is required.
Benefits
- Excellent adhesion
- Rapid strength gain.
- High strength.
- Corrosion resistant
- Resistant to thermal recycling.
- Low temperature cure.
- May be used in overhead applications.
- Pre packed ready for use.
Application
1. Attach the mixing nozzle to the cartridge (screw down hand tight).
2. Place cartridge into the Anchor Resin Cartridge Gun.
3. Gradually pressurise the cartridge by activating the hand trigger a few times until material passes through the mixing nozzle. Stop pressurising and allow the material to flow until an even colour is obtained (approximately 5-6 inches of extruded material should be adequate).
4. Withdraw the nozzle slowly as the hole fills.
5. Once the required fill is achieved wipe off excess material. Insert the fixing slowly with a rotating action to the desired depth. Once all applications have been carried out, release the pressure by pressing the slide release arm on the back of the trigger stop and pulling back the slide rail.
N.B: Once material has started to extrude through the nozzle over pressurising the system will not increase flow rate, and can cause leakage from the rear of the cartridge.
Product Data Sheets
Technical Data Sheet Safety Data Sheet
